Seat Depth Adjuster, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Move seat depth adjuster forward.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Secure the front seat to the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove the bracket for the front trim. Refer to SEAT SIDE TRIM/CONTROL MODULE/COMPRESSOR BRACKET, REMOVING AND INSTALLING .

-- Disengage the left and right rubber bands -2- at the seat depth adjuster and secure from sliding back using a cable tie, for example.

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the molding -1- for the cover on the seat depth adjuster.

-- Release, disconnect and free up the connector -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -2 to 5-.

-- Release the tabs -2 and 3- and remove the seat cushion retaining plate together with the cover and seat cushion.

Courtesy of AUDI OF AMERICA, LLC

-- Push the cover and seat cushion back or lift up.

-- Disengage and remove the seat depth adjuster from the attachments -1 and 4-.