Overview - Seat Position Sensor

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Seat Position Sensor

Courtesy of AUDI OF AMERICA, LLC

Wiring Harness
- For the seat position sensor/passenger occupant detection sensor/seat belt switch
- Clipped in the seat pan
- Black connector, connector station in the underbody under the seat
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
Passenger Seat Occupant Detection Sensor -G128-
- Only the front passenger side
- Removing and Installing. Refer to Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING .
Passenger Occupant Detection Sensor Bracket
- Clipped in the seat pan
- Removing and Installing. Refer to Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING .
Connector Coupling
- For the Seat Belt Latch
Seat Rail
- Tunnel-side
Seat Position Sensor
- Driver Seat Position Sensor -G553-
- Front Passenger Seat Position Sensor -G554-
- Shown on the front passenger side
- Check using the Vehicle Diagnostic Tester.
- Removing, installing and adjusting. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING
Bolt
- 1.6 Nm