LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ7 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Communication (1 Of 2)) >> 91 Communication >> Sound System >> Control Module/Digital Sound System Amplifier, Removing And Installing >> Digital Sound System Control Module -J525-, REMOVING AND INSTALLING, PREMIUM SOUND SYSTEM (9VS), 7-SEATER WITH 48V VEHICLE ELECTRICAL SYSTEM, THROUGH MY 2020 >> Removing

Digital Sound System Control Module -J525-, REMOVING AND INSTALLING, PREMIUM SOUND SYSTEM (9VS), 7-SEATER WITH 48V VEHICLE ELECTRICAL SYSTEM, THROUGH MY 2020: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7, 2022 Audi S7, and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Remove the luggage compartment floor.

-- Remove the Subwoofer -R211-. Refer to Subwoofer -R211-, REMOVING AND INSTALLING, ONLY 7-SEATER WITH 48V VEHICLE ELECTRICAL SYSTEM .

-- Release and disconnect the connectors -3- from the Digital Sound System Control Module -J525- -1-.

GWWA91-12628Courtesy of AUDI OF AMERICA, LLC

-- Insert the :VAS6223/9  -1- onto the MOST Bus connector -2-.

GWWN97-14374Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows- and remove the Digital Sound System Control Module -J525- -1- with the bracket -2-.

GWWA91-12628Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws -2- and pivot the Digital Sound System Control Module -J525- -1- out of the bracket -3- in the direction of -arrow-.

GWWA91-12629Courtesy of AUDI OF AMERICA, LLC