Control Knob Cover, Replacing: Removing
WARNING: This page is about a different car, the 2022 Audi SQ7, 2022 Audi S7, and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.
To remove the cover an adhesive strip from the replacement part kit is used.
-- First clean the cover thoroughly. Remove the protective film from the adhesive strip.
-- Push the adhesive strip -2- on the cover using thumbs.
-- After a wait time of five seconds the cover can be removed vertically upward in a jerking manner in direction of the -arrow-. Make sure that when removing that the control knob on the chrome ring is counter-held.