Overview - A-Pillar Trim Panel
WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Clip
- Insert in the trim panel
- Replace damaged or deformed clips
- A-Pillar Lower Trim Panel
- Stretch the door seal lip over.
- Removing and Installing. Refer to A-PILLAR LOWER TRIM PANEL, REMOVING AND INSTALLING .
- Clip
- Insert into the gap cover
- Remove the clips that are still in the body mounting points using the Omega Clip Tool: T40280 .
- A-Pillar Gap Cover
- Hook into the A-pillar upper trim panel and clip into the A-pillar
- Stretch the door seal lip over.
- Removing and Installing. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
- A-Pillar Upper Trim Panel
- Press on until it engages audibly
- Stretch the door seal lip over.
- Removing and Installing. Refer to A-PILLAR UPPER TRIM PANEL, REMOVING AND INSTALLING .
- Bolt
- 3.5 Nm
- Clip
- With hooks
- Insert in the trim panel
- Cap
- With the "Airbag" symbol
- Unclip using flat-head screwdriver
- Clip
- Insert in the trim panel
- Remove the clips that are still in the body mounting points using the Omega Clip Tool: T40280 .
- Replace damaged or deformed clips
- Clamp
- Press in completely, it must engage.
- Operating Lever Handle
- For the latch
- Only driver side
- Removing and installing. Refer to LATCH RELEASE LEVER, REMOVING AND INSTALLING .
- Bolt
- Only driver side
- 2.5 Nm