Rear Pull Handle, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the door trim panel. Refer to REAR DOOR TRIM PANEL, REMOVING AND INSTALLING .
-- Place the door trim panel on a soft surface.
-- Remove the insulation mat.
-- Disconnect the connectors at the rear of the door trim panel.
-- Remove the bolts -arrows-.
-- Remove the pull handle with the armrest -1- from the door trim panel.
-- Unclip the switch mount -1- from the pull handle with the armrest -2- using the : T10383/1 -arrow- and remove it.