Pistons, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- The engine is secured to the : VAS6095A . Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
-- Label the installation position and the piston allocation to the cylinder.
-- Mark installation position and allocation of the connecting rod cylinder -item : Connecting Rod.
-- Remove the connecting rod bearing cap and remove the piston and connecting rod upward.
-- Remove the circlip -2- from the piston pin eye.
-- Remove the piston pin -3- using the : VW222A .
TIP:
If difficult to move, heat the pistons to approximately 60 °C (140 °F).
-- Remove the pistons -1- from the connecting rod -4-.