Sub-Assembly Bracket, Removing And Installing, Starter Generator: Installing

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

Replace the O-ring and seals after removing.

-- Coat the new O-rings -4- with coolant.

Fig 1: Accessory Assembly Bracket, Coolant Pump Housing, Connection And O-Rings

Courtesy of AUDI OF AMERICA, LLC

-- Insert the connection -2- into the coolant pump housing -3-.

-- Press the accessory assembly bracket -1- onto the connection, mount the bolts and tighten to tightening specification. Refer to Figure.

-- Install the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Install the A/C compressor. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING ON BRACKET .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Install the oil filter element and check the oil level. Refer to ENGINE OIL .

NOTE:

Used coolant cannot be used again.

-- Fill the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .