Sub-Assembly Bracket, Removing And Installing, Generator: Installing

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the bolts that were tightened with an additional turn after removing them.
Replace the O-ring and seals after removing.
Used coolant cannot be used again.

-- Coat the new O-rings -4- with coolant additive.

Fig 1: Accessory Assembly Bracket, Coolant Pump Housing, Connection And O-Rings

Courtesy of AUDI OF AMERICA, LLC

-- Insert the connection -2- into the coolant pump housing -3-.

-- Slide the sub-assembly bracket -1- onto the connection and then install and tighten the bolts.

-- Install the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Install the A/C compressor. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING ON BRACKET .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Install the oil filter element and check the oil level. Refer to ENGINE OIL .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .

There are additional procedures depending on the model. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .