Coolant Pump Toothed Belt, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the bolt -1- and move the bracket -2- with the engine wiring harness to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the screw-type clamp -arrow- and remove the air duct hose from the Throttle Valve Control Module -GX3-.

Fig 1: Locating Air Guide Hose Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Lift the clamps -1, 2 and 3-, remove the coolant hoses and push them to the side.

Courtesy of AUDI OF AMERICA, LLC

All additional procedures are described. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .