Engine Mount
WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Subframe
- Assembly Mount Sensor
- For vehicles with high-voltage system
- Assembly Mount Sensor 1 -G748-, right
- Assembly Mount Sensor 2 -G749- left
- Removing and Installing. Refer to SUBFRAME MOUNT SENSOR, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 2.
- For vehicles with high-voltage system
- Bolt
- 10 Nm
- For vehicles with high-voltage system
- Bolt
- 55 Nm
- Bolt
- 20 Nm
- Bolt
- 10 Nm
- Support Bearing
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 1.
- Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- Bolt
- 55 Nm
- Bolt
- 10 Nm
- Heat Shield
- Engine Mount
- Vehicle without high-voltage system with
- Left Electrohydraulic Engine Mount Solenoid Valve -N144-
- Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- Vehicle with high-voltage system with
- Assembly Mount Actuator 1 -N513-, right side
- Assembly Mount Actuator 2 -N514- left
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Vehicle without high-voltage system with
- Bolt
- 90 Nm + 90°
- Replace after removing
- Bolt
- 30 Nm
Left Support Bearing - Installation Position
- The raised section -2- of the engine support must engage into the opening -1- on the support bearing.
Installation Position - Sensor with Assembly Mount Actuator
- The sensor with the actuator -2- must engage in the hole -arrow- on the engine mount -1-.