Torsion Damper, Removing And Installing: Installing

Fig 1: Carefully Set Down Electro-Drive Drive Motor

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal and note the following:

-- Thoroughly clean the seal -arrow B- and the transmission housing in the accessible area to the differential -arrow A-.

• A damaged seal between the differential and transmission housing -arrow B- must be replaced. Refer to the appropriate service information .

-- Fill the area between the sealing/dust lip -arrow- halfway with Sealing Grease: G 052 128 A1  .

Fig 2: Identifying Oil Seal

Courtesy of AUDI OF AMERICA, LLC

-- Coat the input shaft -arrow- thinly with Grease For Clutch Plate Splines: G 000 100  .

Courtesy of AUDI OF AMERICA, LLC

-- Slide on the torsion damper -1- with the : T40176  carefully and without tilting all the way on the input shaft.

-- Remove the : T40176  from the torsion damper

-- Install the left flange shaft. Refer to the appropriate service information .