Fuel Tank Leak Detection Module -GX36-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2022 Audi Q7, 2021 Audi Q7, and 2020 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the right rear wheel housing liner. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Release and disconnect the connector -2-.
-- Loosen the hose clamp -6- and remove the vent hose -4- from the filter -5-.
-- Remove the bolts -arrows-.
-- Remove the Fuel Tank Leak Detection Module -GX36- -3- with hose -4- and bracket -1-.
-- Remove the bolt -4-.
-- Remove the bolts -arrows- and remove the bracket -1-.
-- Loosen the hose clamp -2- and remove the vent hose -3-.
-- Remove the hose -2- from the Fuel Tank Leak Detection Module -GX36- -1- in direction of -arrow A-.
-- Push the releases together for this in direction of -B arrows-.