Clamping Sleeve Installation Position
WARNING: This page is about a different car, the 2022 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
Installation Position of the Right Clamping Sleeve
-- Install the clamping sleeve in the position shown.
- Angle -α- = approximately 35°±5°.
- Threaded connection to the right.
- The nuts are toward the top.
Installation Position of the Left Clamping Sleeve
-- Install the clamping sleeve in the position shown.
- Angle -α- = approximately 35°±5°.
- Threaded connections are to the left.
- The nuts are toward the top.