Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING: Notes

WARNING: This page is about a different car, the 2022 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Slide Hammer Set - Hook: VW771/37 from Slide Hammer Set: VW771

Fig 1: Identifying Slide Hammer Set
Courtesy of AUDI OF AMERICA, LLC
Puller - Unit Injector - Adapter 3: T10055/3

Fig 2: Identifying Puller Unit Injector Adapter 3
Courtesy of AUDI OF AMERICA, LLC
Injector/Combustion Chamber Seal Tool Set - Sliding Hammer: T10133/3 from Injector/Combustion Chamber Seal Tool Set: T10133C

Fig 3: Identifying Injector/Combustion Chamber Seal Tool Set
Courtesy of AUDI OF AMERICA, LLC
Thrust Piece: T40357 , not illustrated
M10x20 Threaded Pin

Tool Preparation

Courtesy of AUDI OF AMERICA, LLC

-- Assemble the Injector/Combustion Chamber Seal Tool Set - Sliding Hammer: T10133/3 with Slide Hammer Set - Hook: VW771/37 to so this use the Puller - Unit Injector - Adapter 3: T10055/3 and threaded pin -1-.