Lower Timing Chain Cover, Removing And Installing: Removing

• The transmission is removed. Refer to the appropriate Service Information .

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Remove the upper timing chain covers. Refer to UPPER TIMING CHAIN COVERS, REMOVING AND INSTALLING .

-- Remove the rear coolant pipe 5. Refer to COOLANT PIPES, REMOVING AND INSTALLING .

-- Disconnect the connector -2- for the Engine Speed Sensor -G28-.

Fig 1: After-Run Coolant Pump -V51-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and -1 through 17-.

Fig 2: Lower Timing Chain Cover, Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- To loosen the lower timing chain cover -1-, install the three bolts as follows all the way.

Courtesy of AUDI OF AMERICA, LLC

• -left arrow- : M6x20 bolt
• -lower arrow- : M6x20 bolt
• -right arrow- : M6x60 bolt

-- Install each bolt ¹ /₂ turn, until the lower timing chain cover has loosened.

-- Remove the bolts again, remove the lower timing chain cover and remove the transmission side crankshaft seal.