Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is removed. Refer to the appropriate Transmission Information .
-- Insert the Counterhold - Flywheel: 10-201 to loosen the bolts.
CAUTION:
Risk of damaging the outer surface of the bearing flange at the drive plate if handled incorrectly.
- To loosen and tighten the drive plate bolt use the following tools.
-- Use an internal multi-point socket with a shaft that is at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts, drive plate -1- and sensor wheel.