Crankshaft, Removing And Installing: Notes
WARNING: This page is about a different car, the 2022 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Puller - Unit Injector: T10055
- Torx Bolt Driver - T25: T10248 , not illustrated
- Locking Pin (3 pc.): T40011
- Extracting Tool : T40332
- Locking Tool: T40362 , not illustrated
Prepare the Extracting Tool : T40332
-- Tighten the pull rod -1- with the bolts -arrows- as shown on the puller cross bar Extracting Tool: T40332 .
-- Remove the threaded pins -2- for later assembly of the tool.