Wheel Bolt Versions

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

The wheel bolts are different lengths and have ball bearing surfaces depending on the model.

The wheel bolts and wheels will only be secured correctly if the correct wheel bolts are used.

Make sure the correct wheel bolts are installed. Refer to Parts Information.

The ball bearing surfaces of the wheel bolts must be free of grease and clean.

The ball bearing surfaces of the wheel bolts must "not be greased or oiled".

Cup shape explanations

There are two cup shapes: rounded and conical.

The spherical cap has a curved surface -arrow A- on the section of a sphere. This design of the spherical cap was used for original rims.

Fig 1: Identifying Wheel Bolt Versions

Courtesy of AUDI OF AMERICA, LLC

The conical spherical cap has a flat surface -arrow B- on the section of a sphere. This design of the spherical cap is used partially on rims from the accessories program.

I - Wheel Bolt with Spherical Cap

II - Wheel Bolt with Cone-Shaped Spherical Cap

NOTE:

Make sure the correct wheel bolts are installed. Refer to the Parts Information.

Only the same wheel bolts may be installed on all four wheel rims for every vehicle.

Standard, One-Piece Wheel Bolt.

Fig 2: Identifying One-Piece Wheel Bolt

Courtesy of AUDI OF AMERICA, LLC

Two-Piece Wheel Bolts with Short Rotatable Spherical Cap.

Fig 3: Identifying Two-Piece Wheel Bolt, Short Turnable Spherical Calotte, Primarily For S Models

Courtesy of AUDI OF AMERICA, LLC

Two-Piece Wheel Bolts with Long Rotatable Spherical Cap.

Fig 4: Identifying Two-Piece Wheel Bolt, Short Turnable Spherical Calotte, Primarily For S Models

Courtesy of AUDI OF AMERICA, LLC