LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ7 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Wheels, Tires, Wheel Alignment (Wheel And Tire Guide General Information)) >> 44 Wheels, Tires, Wheel Alignment >> Tire Pressure Monitoring System >> Metal Valve, Removing And Installing >> Metal Valve, Removing And Installing, Version 1 >> Installing

Metal Valve, Removing And Installing, Version 1: Installing

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Clean the valve hole.

-- Insert the metal valve into the valve hole, attach the washer and tighten the union nut to tightening specification.

-- Secure the valve using the 2 mm pin against turning.

Fig 1: Securing Against Turning With Counter Hold
GWWA44-0085Courtesy of AUDI OF AMERICA, LLC

-- Install the tire pressure monitoring sensor.

scientia non olet · About LEMON Manuals