EXHAUST GAS TEMPERATURE SENSORS Exhaust Gas Temperature Sensor 3 -G495- /Exhaust Gas Temperature Sensor 3 Bank 2 -G497-, REMOVING AND INSTALLING, 3.0L ENGINE: Removing

WARNING: This page is about a different car, the 2022 Audi S7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Exhaust Gas Temperature Sensor 3 -G495- Cylinder Bank 1 (Right)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector -2- from the bracket, disconnect it, and free up the wire.

CAUTION:

There is a risk of burn injuries due to a hot exhaust system.

Possible to burn hands and other parts of the body.

- Allow the exhaust system to cool.

-- Remove the Exhaust Gas Temperature Sensor 3 - G495- -1- with a suitable tool from the Diesel Engine Tool Set :T10395B .

Exhaust Gas Temperature Sensor 3 Bank 2 - G497- Cylinder Bank 2 (Left)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector -1- from the bracket, disconnect it, and free up the wire.

CAUTION:

There is a risk of burn injuries due to a hot exhaust system.

Possible to burn hands and other parts of the body.

- Allow the exhaust system to cool.

-- Remove the Exhaust Gas Temperature Sensor 3 Bank 2 - G497- -2- with a suitable tool from the Diesel Engine Tool Set :T10395B .