Engine Mount, Removing And Installing: Removing

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the affected front wheel. Refer to Wheels and Tires .

-- Remove the affected front wheel spoiler, and loosen the front of the front wheel housing liner and press it to the side. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Disconnect the connector -2- for the electrohydraulic engine mount solenoid valves.

Courtesy of AUDI OF AMERICA, LLC

Left Engine Mount: 

-- Remove the bolt -1- for the support bearing.

-- Remove the bumper cover end plate. Refer to OVERVIEW - BUMPER COVER .

-- Disconnect the connector -2- for the Charge Air Pressure Sensor -G31-.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the screw-type clamp -1- and remove the air duct pipe from the Throttle Valve Control Module -GX3-.

-- Loosen the screw-type clamp -1-, detach the air duct hose and remove it downward.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -arrow- for the A/C compressor.

Courtesy of AUDI OF AMERICA, LLC

Right Engine Mount: 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right support bearing. Refer to SUPPORT BEARING, REMOVING AND INSTALLING .

-- Loosen the screw-type clamp -arrow- and remove the air duct hose.

-- Free up the wiring duct -2- from the bracket and the subframe.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and the bracket.

-- Remove the nut -arrow- and free up the ground wire.

Courtesy of AUDI OF AMERICA, LLC

Continuation for Both Sides: 

Courtesy of AUDI OF AMERICA, LLC

-- Support the engine in the installation position (refer to ENGINE, SUPPORTING IN INSTALLATION POSITION ) and pretension it with the : 10-222A/11  until the pressure on the engine mount is released.

-- Remove the bolts -arrows- and engine mount -1-.