Automatic Seat Belt TENSIONING, 100: Installing: Notes
NOTE:
Plastic barrel clips on release cable and retractor cable ends must always be replaced.
Retaining clips for cables on retaining brackets must always be replaced. Different cables are required for different transmission versions. Refer to CABLE IDENTIFICATION .
WARNING:
Do not apply grease to plastic barrel clips, retaining brackets, cable ends or cable mounting grooves in retaining brackets.
-- Install new plastic barrel clip on end of release cable.
-- Install new plastic barrel clip on retractor cable end.
-- Lightly lubricate grommet for release cable in front panel.
-- Lightly lubricate cable in area of grommet.
-- Insert cable through grommet from inside.
- Ensure grommet is properly installed into front panel to prevent leaks.
-- Install cable so white assembly mark -4- is in front of grommet -3- in front panel.