LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> S6 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 378 (Passenger Protection, Airbags, Seat Belts (Child Seat Anchors - Special Tools)) >> 69 Passenger Protection, Airbags, Seat Belts >> Seat Belts >> Overview - Outer Rear Three-Point Seat Belt

Overview - Outer Rear Three-Point Seat Belt

WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Outer Rear Three-Point Seat Belt
GWWA69-11520Courtesy of AUDI OF AMERICA, LLC
  1. Bolt
    • Replace the bolt if it was removed because of an accident when the seat belt was buckled.
    • 40 Nm
  2. Connector
    • Equipped on some models
    • For
      • Left Rear Seat Belt Tensioner Control Module -J1097-
      • Right Rear Seat Belt Tensioner Control Module -J1098-
  3. Connector
    • For
      • Driver Side Rear Seat Belt Tensioner Igniter -N196-
      • Passenger Side Rear Seat Belt Tensioner Igniter -N197-
  4. Rear Seat Belt
    • Vehicles with an electric seat belt tensioner
    • with
      • Driver Side Rear Seat Belt Tensioner Igniter -N196-
      • Passenger Side Rear Seat Belt Tensioner Igniter -N197-
      • Left Rear Seat Belt Tensioner Control Module -J1097-
      • Right Rear Seat Belt Tensioner Control Module -J1098-
    • Allocation. Refer to the Parts Information.
    • The Left Rear Seat Belt Tensioner Control Module -J1097- / Right Rear Seat Belt Tensioner Control Module -J1098- must be adapted after replacing the safety belt using the Vehicle Diagnostic Tester.
    • Removing and Installing:
  5. Seat Belt Guide, Avant
  6. Rear Seat Belt
  7. Bolt
    • 40 Nm
    • Replace the bolt if it was removed because of an accident when the seat belt was buckled.
  8. Seat Belt Guide
  9. Bolt
    • 40 Nm
    • Replace the bolt if it was removed because of an accident when the seat belt was buckled.
  10. Belt End Fitting