Airbag Connector, Replacing: Installing
WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
CAUTION:
Pyrotechnical components can deploy unintentionally.
There is a risk of injury.
- Discharge static electricity by briefly touching the door striker.
-- Connect the connector -1- to the airbag igniter in direction of -arrow A-.
-- Press in the connector lock -2- in direction of -arrow B-. While doing this, the connector is pushed into the airbag igniter all the way and locks into place.
- If the instrument cluster indicates a fault in the airbag system after assembly, the DTC memory must be checked, erased, and then checked again. Refer to Vehicle Diagnostic Tester.