LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> S4 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Glass, Window Regulators) >> 64 Glass, Window Regulators >> Side Windows >> Rear Side Window, Removing And Installing >> Damaged Side Window, Removing

Damaged Side Window, Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Procedure 

A4 Avant: 

-- Remove the C-pillar trim panel. Refer to C-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

-- Disconnect the connector -1- and free up the wiring harness -2-.

GWWA64-10538Courtesy of AUDI OF AMERICA, LLC

A5 Coupe: 

-- Remove the front roof trim molding. Refer to ROOF TRIM MOLDING, REMOVING AND INSTALLING .

-- Remove the inner door seal near the side window. Refer to INNER DOOR SEAL, REMOVING AND INSTALLING, A5 COUPE .

A5 Sportback: 

-- Remove the C-pillar trim panel. Refer to C-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the D-pillar trim panel. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the door seal in the side window area.

Continuation: 

CAUTION:

Risk of injury to the hands and eyes from glass fragments.

Getting cut is possible.

- Wear protective eyewear.

- Wear safety gloves.

-- Protect the body and vehicle interior from glass splinters.

-- Tape off the flange all the way around with fabric-reinforced adhesive tape.

-- Remove the glass pieces up to the adhesive.

-- Cut through the adhesive (with glass remnants) in the opening for the window using a : VAG1561A  and : VAG1561/10  (with stopper roll).

-- Remove the separated centering pin from the securing hole.