Height Adjustment, Checking
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Gauge - Frameless Window: T10391
If the side window causes wind noise, the height adjustment must be checked.
Procedure
-- Determine the measuring point on the side window:
- Dimension -a- = 125 mm, measured from the door window rear edge -1-. Refer to ADJUSTMENT DIMENSIONS - Gap dimension -d- = 125 mm .
-- Position the : T10391 on the upper edge of the side window.
-- Move the side window -1- to the "closed" position and measure the disk immersion depth to the convertible top -2-.
- Dimension -f-. Refer to ADJUSTMENT DIMENSIONS - Gap dimension -f- = 8.8 mm .
-- Adjust the height adjustment if the side adjustment is not OK. Refer to HEIGHT ADJUSTMENT .