Overview - Rear Window, A5 SPORTBACK

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The following dimensions represent the distances at the marked points. This must also be oriented to the layout of the original adhesive bead on the removed component.

Fig 1: Rear Window, A5 Sportback Overview

Courtesy of AUDI OF AMERICA, LLC

Rear Window
- Removing and Installing. Refer to UNDAMAGED REAR WINDOW, REMOVING, A5 SPORTBACK .
- Center at the sides
- Pay attention to the distance to the side panel
  - Dimension -b- = 3.0 mm.
Adhesive Bead
- Observe the minimum curing time. Refer to MINIMUM CURING TIMES FOR BONDED WINDOWS .
- Note the different distances to the window edge
  - Dimension -a- = 35.3 mm
  - Dimension -c- = 16.2 mm
  - Dimension -d- = 18.1 mm
- Adhesive bead thickness. Refer to Adhesive Application: .
Rear Window Frame
- In the rear lid
Spacer
- Place on the markings made on the ceramic coating
- Quantity: 8
Side Panel
Locating Pins
- Quantity: 2
Securing Hole