Overview - Rear Window, A4 Sedan And A5 Coupe

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The following dimensions represent the distances at the marked points. This must also be oriented to the layout of the original adhesive bead on the removed component.

Fig 1: Rear Window, A4 Sedan, A5 Coupe Overview

Courtesy of AUDI OF AMERICA, LLC

Rear Window
- Removing and Installing. Refer to REAR WINDOW, REMOVING AND INSTALLING .
- Distance to roof: dimension -a- = 2 mm
- Distance to D-pillars: dimension -d- = 3 mm; center if necessary
Adhesive Bead
- Observe minimum curing times. Refer to MINIMUM CURING TIMES FOR BONDED WINDOWS .
- Different distances to window edge:
  A4:
  - Dimension -b- = 15.5 mm
  - Dimension -c- = 14.5 mm
  - Dimension -e- = 27.5 mm
  A5:
  - Dimension -b- = 17.7 mm
  - Dimension -c- = 8.1 mm
  - Dimension -e- = 29.7 mm
- Adhesive bead thickness. Refer to Adhesive Application: .
Rear Window Frame
Spacer
- Place on the markings made on the ceramic coating
- Quantity: 8
Foam Profile
Ground Wire
Nut
- 9 Nm