Convertible Top Drive Hydraulic Cylinder, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi S4, 2022 Audi A4 Quattro, 2021 Audi S4, and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the convertible top. Refer to CONVERTIBLE TOP, REMOVING AND INSTALLING .
-- Release the clamp -4- and remove the retaining pin -1 and 3-.
-- Remove the hydraulic cylinder -2- from the main bearing.
If the hydraulic cylinder is being replaced:
- Hydraulic Line, Removing. Refer to HYDRAULIC LINE ON CYLINDER, REMOVING AND INSTALLING .
- Left hydraulic cylinder: free up the wiring harness and remove the Convertible Top Stowed Position Switch -F171- / Convertible Top Front Closed Position Switch -F202-. Refer to Convertible Top Stowed Position Switch -F171- /Convertible Top Front Closed Position Switch -F202-, REMOVING AND INSTALLING .