Lifter, Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Clean the adjusting screw threads -3- with a wire brush.
-- Remove any residual locking fluid from the threaded hole of the lifter -1- using a thread tap.
-- Check the stop washer -2- for damage and replace the lifter, if necessary.
- The stop washer must sit in the groove -arrow-.
-- Install the adjusting screw with locking fluid in the lifter.
-- Insert the lifter into the roof opening and secure it with the adjusting screw.