Sill Panel Trim, Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- The vehicle and the trim must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- Remove the protective film from the adhesive tape -1 and 3-.
-- Position the sill panel trim -2- over the pins on the side sill -arrows-.
-- Push the sill panel trim onto the side sill using the : 3356 .
- Resting time approximately 30 minutes at room temperature
Further installation is the reverse order of removal.