Side Panel Trim, Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- The vehicle and the trim must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- Remove the protective film -1- from the adhesive tape -3-.
-- Position the fender trim -2- under the pin on the fender -arrows-.
-- Push the fender trim on the fender until it engages.
- Resting time approximately 30 minutes at room temperature