Upper Front Tunnel Heat Shield, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- TFSI vehicles: remove the front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .

-- TDI vehicles: remove the front exhaust pipe. Refer to the appropriate Service Information .

-- Remove the driveshaft. Refer to the appropriate Service Information .

-- Place the : T10337 on the : VAS6931 and position it at the bottom of the transmission.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the tunnel crossmember bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

TIP:

For reasons of clarity, the : T10337 is not shown.

-- Lower the engine/transmission assembly by dimension -a- using the : VAS6931 .

Fig 1: Engine And Gearbox Jack VAS 6931

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- = maximum 40 mm.

-- Free up the wiring harness -4-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the lock washers -1-.

-- Remove the nuts -2-.

-- Remove the heat shield -3-.