Roof Frame Cover, Removing And Installing, A5 SPORTBACK: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- The vehicle and the roof frame cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution :D 009 401 04 and let dry.
-- Fold back the ends of the protective film, or attach a pulling aid -3- to the protective films.
-- Align the roof frame cover -1- with the centering pin -6- on the body -5-.
-- Drive in the roof frame cover retaining bolt -2- in the mount -4- all the way.
-- Remove the protective film on the pulling aids from the adhesive tape.
-- Press the roof frame cover on until it audibly engages.
-- Push on the roof frame cover in the area of the adhesive surface from inward outward.
- Resting time approximately 30 minutes at room temperature