Roof Frame Cover, Removing And Installing, A4 AVANT: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- The vehicle and the roof frame cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution :D 009 401 04 and let dry.
-- Align the roof frame cover -1- with the centering pin -4- on the body -3-.
-- Remove the protective film from the adhesive tape -2-.
-- Press the roof frame cover on until it audibly engages.
-- Press the roof frame cover on near the adhesive surface.
- Resting time approximately 30 minutes at room temperature