Rear Lid Seal, Removing And Installing, A4 Sedan: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
Before Product Improvement:
-- Position the rear lid seal on the body flange.
- The butt joint -1- for the rear lid seal must face toward the center of the left tail lamp.
- The top of the cover lip -4- must be aligned with the center -2- of the window crossmember -3-.
-- Press on the entire length of the rear lid seal.
From Product Improvement:
-- Position the rear lid seal on the body flange.
- The butt joint -1- of the rear lid seal must be positioned centered to the striker.
- The top of the cover lip -4- must be aligned with the center -2- of the window crossmember -3-.
-- Press on the entire length of the rear lid seal.