Rear Lid Control Module -J605-, REMOVING AND INSTALLING, A4 AVANT: Removing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the roof end strip. Refer to ROOF END STRIP, REMOVING AND INSTALLING .
-- Disconnect the connectors -1 and 2-.
-- Release the catches -4 and 5- and at the same time push the control module -3- to the right side in direction of -arrow-.
- Doing so disengages the brackets from the guides.
-- Remove the Rear Lid Control Module -J605-.