LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> S4 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Hood, Lids) >> 55 Hood, Lids >> Rear Lid >> Gas-Filled Strut, Removing And Installing >> Removing

Gas-Filled Strut, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the rear lid or secure it from falling.

-- A4 Sedan: remove the right luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Using a small screwdriver, lift the locking spring -1- slightly and remove the gas-filled strut -2- from the upper ball pin.

Fig 1: Lifting Locking Spring Using Small Screwdriver
GWWA55-10891Courtesy of AUDI OF AMERICA, LLC