Hinges, Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Install the hinge according the marking made during removal.
-- Adjust the hinge. Refer to SIDE, LENGTH AND HEIGHT ADJUSTMENT AT HINGE .
If the fender flange is being replaced the following adjustment should be performed:
-- Position the hinge -1- as shown and install the bolts -2-.
- At the same time the threads -3- are located in the lower rear corner. This corresponds to the maximum distance of the hood.
-- Adjust the hinge. Refer to SIDE, LENGTH AND HEIGHT ADJUSTMENT AT HINGE .
- When opening and closing the hood or the front doors pay attention to the clearance.