Rear Lid Tail Lamp, Removing And Installing, Sedan: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and Note The Following :
-- Check the self-adhesive seal -2- on the tail lamp -1- for damage.
- A damaged or incorrectly attached seal must be replaced.
TIP:
Water can get into the vehicle interior due to a damaged or incorrectly applied seal.
-- Insert the tail lamp and tighten the nuts.
-- Place the cover -2- on the tail lamp -1- in direction of -arrows- and then press it on.