Front Sensor, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Loosen the wheel housing liner in the front area and push it aside. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Press both retainers to the side in the direction of -arrows- and at the same time, push the sensor -1- through from the outside toward the inside.

Fig 1: Removing Front Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- by sliding the retainer -3- toward the rear and pressing the release down.