Engine Support, Removing And Installing: Removing

WARNING: This page is about a different car, the 2020 Audi A4, 2019 Audi A4, 2018 Audi A4, and 2017 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER .

-- Lift up the clamp -3- and remove and free up the coolant hose.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1- for the Engine Coolant Level Warning Switch -F66-.

-- Remove the bolt -4-, and push the coolant expansion tank -2- to the side.

-- Remove the upper bolts -2- for the engine support -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

For clarity, the removed engine is shown.

The bolts -3- are removed later.

-- If installed, remove the left support bearing. Refer to SUPPORT BEARING, REMOVING AND INSTALLING .

-- Remove the left engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

-- Disconnect the connector -arrow- from the A/C compressor.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the lower bolts -3- and the left engine support -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

For clarity, the removed engine is shown.