Engine Support, Removing And Installing, Vehicles With Natural Gas Fuel Systems: Removing
WARNING: This page is about a different car, the 2020 Audi A4, 2019 Audi A4, 2018 Audi A4, and 2017 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the left support bearing. Refer to SUPPORT BEARING, REMOVING AND INSTALLING .
-- Remove the left engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING, VEHICLES WITH NATURAL GAS FUEL SYSTEMS .
-- Remove the ribbed belt. Refer to CYLINDER BLOCK, BELT PULLEY SIDE [For engine(s) DBPA] .
-- Remove the A/C compressor from the bracket. Refer to A/C COMPRESSOR .
-- Remove the bolts -2 and 3- and the left engine support -1-. (Shown with the engine removed.)