Brake Pad Wear Indicator Wire, Removing And Installing: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Check the brake pad wear indicator contact for damage and replace if necessary.
- Make sure that the brake pad wear indicator contact fits correctly in the brake pad.
- If the clips go missing, the brake pad wear indicator wire must be replaced.
-- Insert the contact -1- for the brake pad wear indicator with the clip -2- until it engages in the inner brake pad.
-- Secure the brake pad wear indicator wire with the protective cap -3- and the clip -4-.
-- Bring the connector -1- into its installation position and turn in the direction of the -arrow- until the tab -3- engages in the hole -4- on the bracket.
-- Connect the connector -2-.