General Information
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of injury. Follow all warning messages and safety precautions. Refer to WARNINGS AND SAFETY PRECAUTIONS .
It is not necessary to disconnect or remove the Battery -A- when using the :VAS5097A .
The following Batteries -A- can be tested using the :VAS5097A :
- 80 to 499 A cold crank amps according to German Industry Standardization DIN (Deutsche Industrie Norm). Refer to ) GENERAL INFORMATION - Batteries -A- with cold crank amps greater than 499 A according to DIN can be tested with the setting for 499 A according to DIN..
- 95 to 574 A cold cranking output according to IEC (International Engineering Consortium)
- 136 to 855 A cold cranking output according to EN/ SAE (Europαische Norm/ Standard of Automotive Engineers)
- Batteries -A- with cold crank amps greater than 499 A according to DIN can be tested with the setting for 499 A according to DIN.
The Batteries -A- are tested by being loaded with current that corresponds to the starter current of a vehicle. Under this load, the Battery -A- is evaluated and the measured results are output through the printer.
NOTE:
Read the :VAS5097A Operating Instructions and :VAS5097A Quick Reference Guide label on the :VAS5097A and the cold crank amps table. Refer to COLD CRANK AMPS TABLE .
- :VAS5097A device description. Refer to Battery Tester with Printer .
- Battery load test. Refer to BATTERY LOAD TEST .
- Cold crank amps table. Refer to COLD CRANK AMPS TABLE .
- Battery load test results. Refer to BATTERY LOAD TEST RESULTS .
- Printed test results explanations. Refer to PRINTED TEST RESULTS EXPLANATIONS .
- Test result evaluation. Refer to TEST RESULT EVALUATION .