BATTERY, CHARGING WITH Battery Charger :VAS5906: Procedure

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the :VAS5906 in the engine compartment or under the vehicle.

-- Connect the :VAS5906 to the power supply.

The :VAS5906 is in idle, the display comes on when it is "ready to be used".

WARNING:

Risk of injury. Follow all warning messages and safety precautions. Refer to WARNINGS AND SAFETY PRECAUTIONS .

CAUTION:

Turn off the ignition and all electrical equipment.
Remove the key.

-- Connect the red charge terminal (+) to the positive terminal of the Battery -A-.

NOTE:

On vehicles with a Start/Stop function and an installed Battery Monitoring Control Module -J367-, the black charge terminal (-) must be connected to the body ground. The Start/Stop system will malfunction when it is connected to the Battery -A- negative terminal.

-- Connect the black charge terminal (-) to the negative terminal of the Battery -A- /negative connector.

The charging process starts after approximately two seconds.

LEDs show the Battery -A- charge level. When all the lamps are on, the Battery -A- is charged.

When the Battery -A- is completely charged, the :VAS5906 automatically switches to maintenance charging.

CAUTION:

Sparks can result if the charging terminals are removed too early. End the charging process by pressing the START/STOP button.

Battery -A- Charging, Ending

-- Press the START/STOP -button.

-- Remove the charging clamps from the battery terminals.

-- Disconnect the :VAS5906 from the power.