Starter, Removing And Installing, Vehicles With 2.0L TDI Engine (0K4): Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and Note The Following :
-- Check the sealing piece -arrow- for the correct installation position.
TIP:
If the starter assembly is difficult to move, use a silicone-free lubricating spray.
CAUTION:
There is a risk of damaging the starter through improper handling.
- Tighten the bolt only with the spacer sleeve installed between the starter and the transmission.
-- Connect the battery. Required actions. Refer to Connecting .