Component Location Overview - Adaptive Cruise Control (Acc)
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Retaining Plate
- Removing and Installing. Refer to RETAINING PLATE FOR DISTANCE REGULATION CONTROL MODULES -J428- / -J850-, REMOVING AND INSTALLING .
- Bolt
- 2.5 Nm
- Quantity: 3
- Clip
- Closed version
- Cannot be removed without being damaged
- Note the installation position
- Clip
- Open version
- Cannot be removed without being damaged
- Stud Bolt
- Note the adjustment dimension. Refer to Installing - MEASURE THE DIMENSION -A- AT ALL STUD BOLTS USING THE DIGITAL CALIPER :VAS6335 AND CORRECT IF NECESSARY. .
- Quantity: 3
- Clip
- Must be replaced when the stud bolt is removed
- Replacing. Refer to CLIP ON Distance Regulation Control Module -J428-, REPLACING .
- Quantity: 3
- Distance Regulation Control Module
- Right: Distance Regulation Control Module -J428-
- Left: Distance Regulation Control Module 2 -J850-
- Removing and Installing. Refer to DISTANCE REGULATION CONTROL MODULES -J428- / -J850-, REMOVING AND INSTALLING .
- Calibrate the adaptive cruise control (ACC). Refer to ADAPTIVE CRUISE CONTROL (ACC)
- Operating Lever for Adaptive Cruise Control
- Shared component with the steering column switch module. Cannot be replaced separately
- Removing and Installing. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .
- Instrument Cluster
- With Instrument Cluster Control Module -J285-
- Front Bumper
- Clip
- Open version
- Cannot be removed without being damaged