Cover And Cushion, Removing And Installing, Bench Seat: Notes

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Pry Lever :80-200

CAUTION:

This procedure may contain mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.

Removing

-- Remove the bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .

-- Remove the clips -1- using the :80-200 .

Courtesy of AUDI OF AMERICA, LLC

-- Pry the cover clamping strip -3- out from the molded part using a screwdriver along the seat frame.

-- Disengage the cover molding -2- from the seat frame at the rear.

-- Disengage the molding -1- from the seat frame.

Courtesy of AUDI OF AMERICA, LLC

-- Pry the clamping strip -4- out of the molded part using a screwdriver.

-- Remove the clips -2- using the :80-200 .

-- Open the Velcro fasteners -3-.

-- Remove the cover and cushion from the seat frame.